太阳能及空气源热泵复合供热系统故障诊断研究与应用

为确保复杂太阳能热水系统的稳定运行,有必要采集实时运行数据从中获取故障特征信号,通过专家系统进行自动故障诊断。采用故障树分析方法,以太阳能热利用系统典型故障为例构建故障树,求解最小割集,并以此为基础建立诊断知识库;运用正向推理结合人工辅助决策机制进行故障诊断和定位,建立故障诊断专家系统。开发故障诊断软件,并在工程中进行测试,验证故障辨识的准确性。     

Heat Transfer Analysis of MHD Power Law Nano Fluid Flow through Annular Sector Duct

Flow and heat transfer analysis of an electrically conducting MHD power law nano fluid is carried out through annular sector duct,under the influence of constant pressure gradient.Two types of nano particles(i.e.Cu and TiO2)are used in power law nano fluid.Strongly implicit procedure,(SIP)is used to simulate the discretized coupled algebraic equations.It has been observed that volume fraction of nano particles,ϕand magnetic field parameter,Ha are favourable for the heat transfer rate,however,both resist the fluid flow.Impact of applied uniform transverse magnetic field exceeds in the case of shear thickening fluids(i.e.n>1)by increasing the value of Ha as compared to that in shear thinning fluids(i.e.n<1).Therefore,enhancement in heat transfer rate is comparably more in shear thickening fluid.Furthermore,comparable limiting case study with published result is also carried out in this research paper.     

某船用柴油机排气管路流-固耦合计算与保温效果研究

对某船用柴油机排气管路的流动与传热过程开展流-固耦合仿真分析。结果表明:受排气管路结构影响，管内流动方向和流速发生变化，局部区域产生明显的回流现象；排气管路外表面温度分布差异较大，平均温度高达534 ℃。为达到柴油机安全设计要求，在排气管路外壁敷设保温材料。分析结果表明:气凝胶纳米材料的保温效果优于硅酸铝纤维材料，在相同的运行条件和使用要求下，气凝胶纳米材料的敷设厚度更薄。     

Potential of performance improvement of concentrated solar power plants by optimizing the parabolic trough receiver

This paper proposes a comprehensive thermodynamic and economic model to predict and compare the performance of concentrated solar power plants with traditional and novel receivers with different configurations involving operating temperatures and locations. The simulation results reveal that power plants with novel receivers exhibit a superior thermodynamic and economic performance compared with traditional receivers. The annual electricity productions of power plants with novel receivers in Phoenix, Sevilla, and Tuotuohe are 8.5%, 10.5%, and 14.4% higher than those with traditional receivers at the outlet temperature of 550°C. The levelized cost of electricity of power plants with double-selective-coated receivers can be decreased by 6.9%, 8.5%, and 11.6%. In Phoenix, the optimal operating temperature of the power plants is improved from 500°C to 560°C by employing a novel receiver. Furthermore, the sensitivity analysis of the receiver heat loss, solar absorption, and freeze protection temperature is also conducted to analyze the general rule of influence of the receiver performance on power plants performance. Solar absorption has a positive contribution to annual electricity productions, whereas heat loss and freeze protection temperature have a negative effect on electricity outputs. The results indicate that the novel receiver coupled with low melting temperature molten salt is the best configuration for improving the overall performance of the power plants.     

Features of Cattaneo‐Christov heat flux model for Stagnation point flow of a Jeffrey fluid impinging over a stretching sheet: A numerical study

The present work focuses on a two‐dimensional steady incompressible stagnation point flow of a Jeffery fluid over a stretching sheet. The Cattaneo‐Christov heat flux model is incorporated into this study. Simulation is conducted via the Runge‐Kutta fourth‐order cum shooting method for the transformed system of nonlinear equations. The influence of the governing parameters on the dimensionless velocity, temperature, skin friction, streamlines, and isotherms is incorporated. A significant outcome of the current investigation is that an increase in the relaxation time parameter uplifts temperature; however, a gradual decrease is observed in the velocity field. Another important outcome of the present analysis is that the momentum boundary layer augments due to an increase in the Deborah number; however, a decrease is observed in the temperature. Furthermore, it is also observed that the skin friction coefficient escalates with an increase in the relaxation time parameter for the assisting flow, but a reverse trend is observed for the opposing flow.     

Stability and thermophysical properties of fly ash nanofluid for heat transfer applications

Improving the performance of heat transfer fluids is altogether significant. The best approach for improving the thermal conductivity is the addition of nanoparticles to the base fluid. In the present study, specific heat, dynamic viscosity, and thermal conductivity of water-based Indian coal fly ash stable nanofluid for 0.1% to 0.5% volume concentration in the temperature range of 30 to 60°C has been investigated. To evaluate an average particle diameter of 11.5 nm, the fly ash nanoparticles were characterized with scanning electron microscopy and dynamic light scattering. Using zeta potential, the stability of nanofluid in the presence of surfactant Triton X-100 was tested. Thermal conductivity and viscosity of fly ash nanofluid increased, while specific heat decreased as volume concentration increased. The effect of temperature on the fly ash nanofluid was directly proportional to its thermal conductivity and specific heat and inversely proportional to viscosity.     

带有蓄热型直接冷凝式加热板的空气源热泵系统性能研究

针对现有的空气源热泵冬季供热系统，提出了一种使用新型蓄热型直接冷凝式加热板（RHP）的空气源热泵供热系统，并测试了RHP的热性能和系统的运行特性，同时分析了系统的效率和经济性。实验结果表明，在39℃的冷凝温度下，RHP的热容量高达1044 W，RHP的蓄热量大于1000 kJ。在室外空气温度为8℃时，系统COP高达3.7。此外，对于20 m²的居住房间而言，该系统的供暖初始投资成本和总运行成本分别为3174.7 CNY和510.7 CNY，在居住建筑冬季供暖领域具有较大的竞争力。     

Thermo-physical and mechanical properties of Yb2O3 and Sc2O3 co-doped Gd2Zr2O7 ceramics

Ceramic materials for the thermal barrier coating (TBC) application of Gd₂Zr₂O₇ (GZO), (Gd_0.94Yb_0.06)₂Zr₂O₇ (GYb_0.06Z), (Gd_0.925Sc_0.075)₂Zr₂O₇ (GSc_0.075Z), (Gd_0.865Sc_0.075Yb_0.06)₂Zr₂O₇ (GSc_0.075Yb_0.06Z), and (Gd_0.8Sc_0.1Yb_0.1)₂Zr₂O₇ (GSc_0.1Yb_0.1Z) were successfully synthesized by chemical co-precipitation. The effects of the doping of Sc₂O₃ and Yb₂O₃ on the phases, thermo-physical and mechanical properties of the ceramics were investigated. The results show that both Yb₂O₃ and Sc₂O₃ doping promoted the phase transition of GZO from pyrochlore to fluorite. All the Sc₂O₃-doped samples exhibited enhanced fracture toughness, as compared to the undoped sample. Furthermore, the GSc_0.075Yb_0.06Z sample revealed a thermal conductivity of ~0.8 W/mK at 1200 °C, which was nearly 30% lower than that of the undoped sample. The associated mechanisms related to the effects of the doping on the thermophysical and mechanical properties are discussed.     

Enhanced ionic conductivity and thermal shock resistance of MgO stabilized ZrO2 doped with Y2O3

The present work focused on the effect of Y₂O₃ co-doping on the phase composition, microstructure, ionic conductivity and thermal shock resistance of 8 mol% MgO stabilized ZrO₂ (Mg-PSZ) electrolyte ceramics for high temperature applications. The addition of Y₂O₃ could promote the process of monoclinic-to-cubic/tetragonal phase transformation and became the metastable phase at room temperature. Meanwhile, the grain size of Mg-PSZ decreased. It was demonstrated that an appreciable increase in the ionic conductivity and compressive strength occurred on substituting MgO with Y₂O₃ in the Mg-PSZ electrolyte ceramics across the measured temperature range. Moreover, the Y₂O₃ addition could restrain the adverse effect of the cyclic thermal shock on the ionic conductivity and compressive strength of Mg-PSZ. The main reason was that the increase of the amount of monoclinic phase caused by cubic/tetragonal-to-monoclinic phase transformation by the cyclic thermal shock was restrained after the Y₂O₃ addition.     

等温退火对8030铝合金导线组织性能的影响

研究了不同等温退火工艺对8030铝合金导线组织及性能的影响。结果表明:等温退火前后合金均由α-Al基体和Al₆Fe相组成。在同一等温温度下,随着等温时间的延长组织逐渐趋于均匀化;同一等温时间下,随着等温温度的升高,组织趋于均匀化的时间缩短。经过等温退火处理后铝合金导线的导电率均有所提高,在470 ℃均匀化退火24 h后再经240 ℃等温4 h,合金导电率达到最高值57.21%IACS,比未经热处理试样的导电率提高了2.4%IACS。经过等温退火处理后铝合金导线的硬度及抗拉强度均有所降低,塑性大幅度提高。在470 ℃均匀化退火24 h后再经260 ℃等温8 h,合金的伸长率最高可达23.64%。热处理前后合金均为塑性断裂。